Add to List
The DMX Hub is a DMX distribution box with 2 dedicated input
connectors and 10 configurable output connectors. All in- and output connectors
conform to the new DMX 512-A standard. This allows half-duplex data transport
on a normal DMX connection such as fixture talk back and RDM (ANSI E1.20).
The hub has 2 separate DMX zones with all outlets protected individually. The hub can be used to distribute 1024 dmx channels on the 2 DMX lines.
This all comes in a 19”, 1 unit high metal housing.
The hub has 10 configurable output connectors (default
configuration with Neutrik 5 pin female). Every outlet has a tiny switch to
select whether it's connected to zone 1 or zone 2. In this way the user can
configure the device to be used to his needs, defining every outlet separately
to a zone. All outlets on the same zone are bi-directional and communicate
Bi-directionality can be disabled per zone. User can thus mix RDM and non RDM devices on the same DMX splitter.
The device operates with an AC voltage between 85V and 264V.
The power management circuit regulates the internal power and loads the
internal backup battery. The internal backup battery insures the operation of
the complete unit for 30 minutes (when fully loaded). This means that during
power failure, your DMX distribution is not interrupted and the complete
optical and galvanic protection remains on every single outlet.
A tri-coloured LED next to the power switch indicates the power situation.
- 2 x DMX512-A in/outputs on 5 pin male XLR, with termination (RDM compliant)
- 10 x DMX512-A in/outputs on 5 pin female XLR, with termination (RDM compliant)
- 1 x IEC socket with fuse holder (90-260 VAC, 47-63 Hz)
- 2 x DMX512-A in/outputs on 5 pin male XLR on the back panel (identical to the 2 zone inputs on the front end)
All specifications are subject to change without notice.
DMX512-A 2.10 Hub by Luminex